eShapeoko - Buildlog stepper shield and DRV8825 drivers
As there are some differences between stepper drivers I'm guessing there will be a couple of changes needed to my grbl set up before I can get it working with the buildlog stepper shield and DRV8825 stepper drivers.
The microstep lines are changed with jumpers, the fault is an output, the sleep and reset need to be held high, not sure how to do this yet or what enable does.
| Arduino pin | Y Axis | X Axis | A Axis | Z Axis |
| Direction | 6 | 5 | 13 | 7 |
| Step | 3 | 2 | 12 | 4 |
| Enable | 8 | 8 | 8 | 8 |
| Sleep/Reset | - | - | - | - |
continued here!
Comments
Post a Comment